Discover

Topics

IF Cockpit

IF Cockpit APK

IF Cockpit APK

1.0.5 FreeNicolas BD

What's IF Cockpit APK?

IF Cockpit is a app for Android, It's developed by Nicolas BD author.
First released on google play in 7 years ago and latest version released in 7 years ago.
This app has 0 download times on Google play
This product is an app in Simulation category. More infomartion of IF Cockpit on google play
Tired of holding your tablet when playing Infinite Flight ? Install IF Cockpit on your phone to control Infinite Flight remotely ! Android/iOS compatible (you can control your iPad with an Android Phone)

* ANDROID 5 OR LATER ONLY*

SEE FEATURES, REQUIREMENTS AND INSTRUCTIONS BELOW :

Features :
- Throttle
- Rudder
- Pitch & Roll (with pan tilt movements)
- Gear (toggle)
- Breaks (toggle)
- Spoilers (toggle: Flight/Armed/Off)
- Flaps (Up/Down)
- Autopilot : SPD, HDG, ALT, VS
- ATC : Open/Close window + 1 to 10 commands
- Lights
- Pushback
- Trim (Up/Down)
- Play/Pause
- Camera (next/previous) + POV
- HUD (enable / disable)
- And more to come !


Requirements & Disclaimer :

- This app requires to install Infinite Flight on another device
- Infinite Flight and IF Cockpit must run and two different devices connected to the same WiFi network
- Disconnections can happen : Relax, all our tests were fine but a connection fail is always possible. The developer of Infinite Cockpit is not responsible for any disconnection due to WiFi or Infinite Flight app related issues. See instructions below to reconnect quickly.

Instructions : [IF] = Infinite Flight, [IC] = IF Cockpit

- [IF] + [IC] Make sure your devices are connected to the same WiFi network
- [IF] Start Infinite Flight
- [IF] Check 'Enable Infinite Flight Connect' in General Settings
- [IF] Start a Flight
- [IC] Click 'Auto Connect'
- [IC] Wait for 'Connected' message in the info panel
- [IF] Go to Settings > Controls
- [IF] - Click on 'Roll' and move your phone to left/right
- [IF] - Click on 'Pitch' and move your phone frontwards/backwards
- [IF] - Click on 'Yaw' and move the 'Rudder' slider left/right
- [IF] - Click on 'Throttle' and move the 'Throttle' slider up/down
- [IF] - Check any 'reverse' box if needed
- [IC] Click 'Auto Setup' at any time to reset connection if needed
- [IC] Click 'Calibrate' at any time to reset axis center